Installation tips for AWMS-2-BT75
This freestanding mount is designed for use with ultrawide monitors, which can be more challenging to move and mount than smaller and lighter displays. We’ve compiled visual setup tips to mount your displays easily and correctly. We recommend you review the installation guide and watch the video before setting your AWMS-2-BT75-FS stand up.
Open this file for a printable version of the installation guide.
AWMS-2-BT75-FS video highlights
Measure to ensure enough space between displays and to the base of the mount (highlight shown as animation).
Do not move mount with displays attached – position mount in desired location on work surface before attaching displays.
Remove screens before loosening bracket hand knob to adjust height.
Inside rear of bracket (inner guide) should slide into the rear channel of the post.
Cable covers should have angled ends at top and base, for cable ingress & egress. Small cable sit within the larger cable covers.
Keep displays straight for most simple setups.
Allow extra space between brackets if tilting curved displays.
Downward force or load at display corners will cause a rocking movement. This is expected. It is recommended you avoid this.
Important tips!
Different sized monitors
- Top and bottom monitors can be different size & model
- Adjust tilt to compensate for different monitor depths
- Having larger monitor in lower position recommended to promote stability
Remove monitors to move
- Don't move mount with displays attached
- Move mount to new location
- Then reattach monitors
Remove monitor to adjust bracket
- Remove monitor before loosening bracket with hand knob
- (Fine-tune adjustment knobs and tilt knobs are designed to use with display attached to bracket/mount)
Long service life & 10-year warranty
Contact our team for advice.